De rol van Lasertechnologie in 3D printen

Bijeenkomst op donderdag 9 mei 2019 bij de Fonthys, Rachelsmolen 1, 5612 MA in Eindhoven. De gastheer is Bert Huis in t Veld.

  

                                    De rol van Lasertechnologie in 3D printen. 


13.30 - 13.45 uur         Ontvangst en Koffie/thee. 

13.45 - 14.00 uur         Bert Huis in t Veld, voorzitter van de Kring voor Materiaalbewerking met Lasers.  

14.00 - 14.30 uur         Lenn Hoek van Dijke van Trumpf: 

TRUMPF Additive Manufacturing (AM) The road towards technology leadership in the field of Laser Metal Fusion 

Over the last 20 years, the development of digital production technologies has increased considerably. One of these increasing technologies is Additive Manufacturing (AM).

In 1999, TRUMPF worked together with Fraunhofer ILT to develop the basis of the technical working principle of the LaserPowderbed Fusion technology (LPBF). In 2003, this led to the introduction of one of the first LPBF systems. In 2006 the production and sales of these systems were discontinued due to (very) limited market adoption. With a relatively late re-entry, TRUMPF is since four years once again active in the field of AM. The creation of a new business division alongside Laser Technology (LT) and Machine Tools (MT) reflects the strategic potential and importance of AM for TRUMPF.

The presentation will provide insight into the route TRUMPF intends to take to become technology leader in the field of Additive Manufacturing once again. The focus of this presentation will be on developments in the field of hardware (new machine concepts, automation, HT pre-heating and applying TRUMPF laser competence in new machine concepts), software (simulation and monitoring) and materials. In addition to technological development, the market and associated business models are also subject to strong change. The presentation will also give an insight on how TRUMPF is undergoing strong developments in this area. 

  14.30 14.45 uur      Pauze

 14.45 - 15.30 uur        Sjef van Gastel van Fontys: AM bij Fontys

 15.30 - 16.30uur         Bezoek aan het OBJEX lab, dat is het 3D printlab van Fontys

 16.30 - 17.00 uur        Netwerkborrel

  

Voor meer informatie klik hier



Datum: 9 May 2019

Tijd: 13:30 - 17:00

Locatie: Fonthys, Rachelsmolen 1, 5612 MA in Eindhoven